LP5562 requires 2.7V min but NFC energy harvesting produces only 1.8V.
New architecture: SAMD21 drives 6 red LEDs directly via TCC0/TCC1
hardware PWM through current-limiting resistors.
Key changes:
- Add TCC PWM driver (src/led/pwm.rs) for 6 GPIO-direct LED channels
- Rewrite pattern engine: software waveform LUTs (sine/triangle/square/
heartbeat) replace LP5562 hardware execution engines
- Add XBLK v2 EEPROM format with 16-byte pattern entries + playlist
- Add TC4 50Hz ISR for animation, power governor for current budget
- Add NTAG5 EH provisioning: persistent config + session trigger
- Critical finding: SRAM passthrough in persistent EEPROM blocks all
NFC access when MCU unpowered — CONFIG_1 must be session-only
- Add provision_eh.py PCSC tool for ACR1552 reader
- Update CLAUDE.md and STATUS.md for new architecture
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
ISO15693 already provides CRC-16 at the transport layer, making
the application-layer CRC redundant. Simplifies header from 6 to
4 bytes, removes crc16_continue/verify_crc, and drops STATUS_BAD_CRC.
Also updates design doc and fixes markdown table formatting.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Hall sensor + LP5562 EN wired-AND circuit design (DRV5032FB/FE,
1M pull-up, open-drain topology) with three interaction modes:
boot-time recovery, tap-to-swap, hold-to-confirm recovery
- NTAG5 config check tool (tools/ntag5_config_check.py) using
uFCoder library for ISO15693 transparent mode via uFR Zero reader.
Supports inventory + addressed mode for multi-tag fields.
- Updated DEVELOPMENT_PLAN with I2C bus management notes for
LP5562 (0x30) + NTAG5Link (0x54) shared bus
- Updated README with wired-AND hardware diagram, hall sensor
interaction section, and updated wiring table
- Updated CLAUDE.md with LP5562 EN wired-AND topology docs
- Updated STATUS.md with hall sensor decisions and hardware inventory
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
- Integrate LP5562 driver from sibling project (ntag5-samd21-lp562)
with full doc comments restored
- Update main.rs with complete M1 test: I2C init, GPIO EN, RGBW cycle
- Rewrite DEVELOPMENT_PLAN.md from waterfall to milestone-based groups
organized by hardware availability (Groups A-E)
- Rewrite STATUS.md with milestone checklist tracking
- Add LP5562 timing constraints and flash script docs to CLAUDE.md
- Add flash_when_ready.sh for auto-flash dev workflow
- Add brainstorm design doc for plan redesign rationale
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
Set up Rust embedded project targeting SAMD21 (thumbv6m-none-eabi) with
XIAO M0 BSP for dev board prototyping. Includes LP5562 EN pin control
on D0/A0, project documentation (README, CLAUDE.md), phased status
tracker, and detailed development plan covering LP5562 driver integration,
NTAG5Link I2C driver, pattern storage format, power management, NFC
communication protocol, recovery mode, and firmware update strategy.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
